Horizontal machining centers and horizontal five-axis machining centers have been rarely introduced since the station was built, because horizontal machining centers are relatively few in the market, and users rarely purchase horizontal machining centers. Generally, users who choose vertical machining centers are more . The reason is that the vertical machining center occupies a small area and is cost-effective; while the horizontal machining center occupies a large area and is more expensive than the vertical machining center, so the general users rarely choose the horizontal machining center. Although it is said that the horizontal machining center is rarely used by users, the editor of the structure of the horizontal machining center should introduce it to let everyone know more about the machining center. Xiaobian mainly introduces the types of horizontal five-axis machining centers today. Horizontal five-axis machining centers can be divided into two types according to the setting of the rotation axis, that is, two rotation axes are set on the table and two rotation axes are respectively Set on the spindle and worktable.
Horizontal five-axis machining center with two rotating shafts set on the table
This type of horizontal five-axis machining center installs two rotary axes on the bed table. One rotary axis is set as the bed table of the horizontal machining center. We are positioned as the A rotary axis. The working range of the A axis is +20 degrees to -100 degrees. A rotary table is set in the middle of the A-axis worktable. We are positioned as the B-axis, and the working range of the B-axis is 360-degree rotation. The linkage characteristics of this type of horizontal five-axis machining center are very good, and it is more suitable for the processing of complex curved surfaces of large impellers.
Horizontal five-axis machining center with two rotary axes set on the table and spindle
The two rotary axes of this type of horizontal five-axis machining center are respectively installed on the main shaft and the worktable, one rotary shaft is installed on the horizontal main shaft as the rotary axis, and the other rotary axis is set as the rotary axis of the table of the bed Five-axis linkage processing. The spindle of this setting mode can be vertical or horizontal. According to the processing needs, the spindle can be converted from vertical to horizontal, and the structure is simple and flexible. The vertical and horizontal conversion of the spindle cooperates with the indexing value of the worktable to realize five-sided machining of the workpiece, the manufacturing cost is relatively low, and it is very practical.
